Cable Connection Scheme - Prointegra Meteobot User Manual

3.11 Cable connection scheme

1. Install the SIM card in your mobile phone and disable the SIM PIN code;
2. Install the SIM card in the SIM card slot on the electronic circuit board;
3. Place the cable ends in the corresponding socket on the electronic circuit board, as
described on the scheme above. Then screw the socket bolts with a small screwdriver.;
3.1. IMPORTANT: Connect the air temperature, relative humidity and air pressure sensor;
the leaf wetness sensor, and the soil temperature sensor to the electronic circuit
board observing the cable colours, as on the scheme;
3.2. For the wind speed sensor, it does not matter which cable is left and which is right.
The same applies for the rain sensor and the soil moisture sensor;
4. Place the battery in the box and connect it to the electronic circuit board. IMPORTANT:
connect the red cable shoe to the red terminal (+) and the blue cable shoe to the black
terminal (-);
5. Connect the solar panel cables to the electronic circuit board one by one, as displayed on
the scheme above.
IMPORTANT: Be careful not to connect them to each other! If you make a short circuit,
the solar panel may get damaged;
6. Close the lid, making sure it fits tightly to the box;
7. Tighten the cable glands (by screwing them clockwise) so that they fit tightly around the
cables;
8. Bind the slack cables to the pole with cable ties.
Page 13 / 22