Charging Pocket Installation; Removing Charging Pocket From Multi-Unit Charger; Securing Charging Pocket To Multi-Unit Charger - Motorola solutions PMLN6621 User Manual

MN000217A01.book Page 7 Thursday, October 29, 2015 12:41 PM
drastically reduce the life expectancy of the battery. When this condition
is corrected, the battery will begin charging automatically (STEADY RED
indication).

CHARGING POCKET INSTALLATION

To reduce risk of electric shock, unplug the charger from the AC outlet before
removing or replacing Charging Pocket.
W A R N I N G

Removing Charging Pocket from Multi-Unit Charger

1. Remove the screw that secures the Charging Pocket to the base.
2. Lift the Charging Pocket a few inches away from the base.
3. Remove the Pocket Harness by pulling straight up on the connector
(refer to Figure 2).

Securing Charging Pocket to Multi-Unit Charger

1. Connect Pocket Harness by plugging in the connector to the receptacle
on Multi-Unit Charger (refer to Figure 3).
2. Slot in the Charging Pocket to the base and ensure the Charging Pocket
is flushed in to the Multi-Unit Charger. Affix the Charging Pocket screw.
7