Charging Procedure; Operating Instructions - Motorola solutions PMLN6621 User Manual

MN000217A01.book Page 4 Thursday, October 29, 2015 12:41 PM
Plug Type
Taiwan
China
Hong Kong
Australia / New Zealand
Korea
Japan
DESCRIPTION
The Multi-Unit Charger comprises a base unit which accommodates six
charging locations. Each charging location is fitted with a charging pocket.
The kit contains:
• 1 Multi-Unit Charger base unit
• 6 charging pockets
• 1 regional line cord

OPERATING INSTRUCTIONS

The Multi-Unit Charger will charge only Motorola Authorized Batteries listed in
Table 1. Other batteries may not charge. Prior to operating the charger, check
that all radio and battery inserts are in place and properly latched.
The Multi-Unit Charger can charge up to 6 radios or batteries (in any
combination) listed in Table 1.
Note: Prior to charging a battery with radio, turn the radio off.

Charging Procedure

1. Plug the charger end of the power supply cord into the power receptacle
located at the back of the charger.
2. Plug the wall receptacle end of the power supply cord into the
appropriate AC outlet. A successful power-up sequence is indicated by a
SINGLE GREEN BLINK on the charger indicator.
3. Insert a battery, or a radio with battery (radio turned off), into the
charger's pocket by:
a. Aligning the groove on each side of the battery with the corresponding
raised rail on each side of the charger pocket.
b. Pressing the battery toward the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring complete contact
between the charger and battery contacts.
Table 2: Authorized Power Cords
Charger Kit
PMLN6613
PMLN6622
PMLN6618
PMLN6619
PMLN6615
PMLN6620
4
Power Cord
3004209T04
3004209T14
3004209T02
3004209T07
3004209T13
3004209T15