Resetting Overheat Protection; Setting Up Frost Protection; Cleaning - Easy@Home CH-Y01AFT User Manual

USA

Cleaning

Resetting overheat protection

The convection heater has an overheat protection. It switches the convection
heater off if it overheats. If you would like to operate the convection heater
again, proceed as follows:
− Switch the convection heater off. For this, move the sliding switch
the timer 14 to and pull the power plug out of the socket with earthing
contact.
− Let the convection heater cool down to room temperature.
− You can then operate the convection heater again.

Setting up frost protection

This function activates the convection heater to prevent the room temperature
from dropping below freezing. Follow the steps below to activate this function:
1. Turn the thermostat control
to MIN).
2. Move the sliding switch
3. Use the switches 650 W
cator lights for the active switches will illuminate.
4. Turn on the fan with the switch
function is activated.
The convection heater now automatically switches on and off to keep the
room temperature above the freezing point.
Cleaning
WARNING! NING!
Burn hazard!
The convection heater will become hot during operation!
− Let the convection heater cool off completely before each
cleaning!
22
serviceusa@tempo.org
13 counterclockwise up to the stop point (up
15 on the timer 14
11 and 850 W 10 to select a heat setting. The indi- to select a he to select a he
will illuminate. ll illuminate.
12 . The indicator light illuminates once the . The indicator The indica
w automatically sw utomatica
ove the freezing po the freezin
15
e room t room t
o activate this activate th
se up to the stop p e up to the sto
to to to . .
AFTER SALES SUPPORT
USA
866-235-5029
on