Easy@Home CH-Y01AFT User Manual page 21

Design of the timer
Setting the timer
1. Set the sliding switch
2. Set the current time on the timer. Turn the timer so that the arrow
pointing towards the current time.
3. Pull the corresponding segment to the outside to preset the beginning of
the heating period. You can set as many segments as you like to the outside
to extend the heating time. All other segments will remain on the inside.
4. With the switches 650 W
heat settings.
5. If necessary, activate the fan te the fan
6. Set the thermostat control tat control control
NOTICE NOTICE NOTICE
If the convec If the conv If the convection heater switches off (indicator lights are
off) alt off) althou off) although it is supposed to produce heat, the room
tem temper temperature set on the thermostat control has been reached.
The convection heater will automatically switch back on he
once the room temperature falls below the set temperature.
You can also turn the thermostat control clockwise until the
convection heater starts to produce heat again.
7. Move the sliding switch on the timer to in order to switch the convection
heater off. Pull the power plug out of the socket if you are not using the con-
vection heater for a prolonged period.
AFTER SALES SUPPORT
USA
866-235-5029
The timer has an adjustable dial. You can turn it
clockwise to set the time.
The timer dial has 96 segments. The segments
are blue.
Each segment is equivalent to 15 minutes of time.
Pulling the segments out sets the heating period.
Segments set to the inside indicate periods with
no heating.
15 on the timer 14 to the symbol o the symbol
timer so that the
the outside to pre e outside to pre
as many segment as many segment
ll other segments ther segme
and 850 W and 850 W and 850 W , select one of the three possible
11 10
he fan 12 12 too. too
to the desired position. to
13
Use and operation p
the symbol . .
so that is
serviceusa@tempo.org
USA
21