Easy@Home CH-Y01AFT User Manual page 16

USA
First use
and that the centering pins are positioned in the housing holes.
The support feet are now attached so that you can see each set of two holes,
which are diagonally opposed.
3. Use two short screws
Make sure that the support feet are straight and secure on the housing. Do
not overtighten the screws; instead only turn the screws into the housing
until hand-tight.
4. Place the convection heater on the support feet.
Mounting the convection heater on the wall
WARNING!
Fire hazard!
The housing of the convection heater gets very hot during oper-
ation. Therefore, follow the instructions below for wall mounting:
− Ensure that there is a distance of at least 1.9 ft (50 cm)
between the bottom side of the convection heater and the
ground (see fig. G).
− Ensure that there is a distance of at least 1.6 ft (40 cm) to a
wall/objects and furniture on the side.
− Ensure there is at least 3.9 ft (1 m) of clearance above the
convection heater and along the periphery (e.g. to furni- ter and along
ture or the room ceiling). oom ceiling). oom ceiling)
− Do not in any case hang the convection heater in a any case hang y case ha
crooked or lopsided position. or lopsided or lopsided p
− Do not use the convection heater without support feet or the conv the
when it is lying flat on the ground. g f
− Make sure that a socket with earthing contact can be
reached without an extension cord.
− The heat must be able to dissipate without obstruction to
prevent the build-up of heat and in order to avoid any risk
of fire. The build-up of heat could trigger the automatic
overheat protection.
16
serviceusa@tempo.org
5 to secure each of the support feet on the housing.
ets very hot dur
ns below for wa below for w
of at least 1.9 f at least 1.9 f
the convectio e convectio
istance of at le tance of a
niture on the s ure on th
least 3.9 ft (1 m ast 3.9 ft
and alon
very ho
AFTER SALES SUPPORT
USA
866-235-5029