Cleaning & Maintenance - Honeywell MN series IM Owner's Manual

CLEANING & MAINTENANCE
Appliance Maintenance:
1. Turn off the appliance before disconnecting the power supply.
2. Always clean the appliance with a soft dry cloth.
The air filter should be cleaned every two weeks.
Clean it as follows:
1. Turn off the appliance and remove the air filter (refer to page 6, #6).
2. Rinse it in lukewarm water. After cleaning, dry in a shaded and cool place, then reinstall.
End of Season Storage & Maintenance:
If the appliance will not be used for a long time:
1. Be sure to drain the left-over water condensation. Remove the lower drain plug and use a
shallow pan to collect the water (make sure to replace the drain plug when finished).
2. To dry excess moisture, run the unit in Fan only mode for 30 minutes before storing.
3. Turn off and unplug the air conditioner from the power supply.
4. Remove the air filter and clean with water. Dry the air filter and then reinstall onto the unit.
5. Disconnecting the Window Installation Kit:
- Remove the Plastic Hose from the unit by rotating it slightly clockwise and pulling
away from the unit at the same time.
- Remove the Window Bracket, Window Bracket Panel Adapter and Hose Connector.
- It is recommended to store the Window Kit parts in a bag together with the Remote
Control and placing them together with the air conditioner unit.
- If needed, you can clean the Window Kit with a damp cloth and water before storing.
Make sure all parts of the Window Kit are dry before storage.
6. Cover the air conditioner with a cloth/ plastic bag before storage, to protect from dust and
scratches collecting on the surface of the unit.
7. It is recommended to coil the power cord and store it away from the floor to ensure the
cord is protected from bents and creases.
13