Installation - Honeywell MN series IM Owner's Manual

INSTALLATION

1 Install the plastic hose with window bracket adapter and hose connector on both sides.
Ensure proper fit on both ends.
2 Adjust the window bracket as per width or height of your window and insert the plastic pins
to fix at the desired position. There is a hole where the Plastic Hose will be inserted later.
Make sure this hole is not blocked.
Plastic Pin
3 Connect the plastic hose to the hose connector on the back of the unit.
Push-in until it is locked in place.
7
=
Note : Do not install the window
bracket to your window. This step is
required only to adjust it to the
size of your window. The bracket
should be removed from the window
after the size is adjusted.
Hole for Plastic Hose