Grandstream Networks GWN7600 User Manual page 53

RADIUS NAS ID
Enable Dynamic VLAN
Client Bridge Support
Client Time Policy
Use MAC Filtering
Client Isolation
Gateway MAC Address
Enter the RADIUS NAS ID.
This field is available only when "WPA Key Mode" is set to "802.1x".
When enabled, clients will be assigned IP address from corresponding
VLAN configured on the RADIUS user profile.
This field is available only when "WPA Key Mode" is set to "802.1x".
Configures the client bridge support to allow the access point to be
configured as a client for bridging wired only clients wirelessly to the
network. When an access point is configured in this way, it will share the
WiFi connection to the LAN ports transparently.
Once a SSID has a Client Bridge Support enabled, the AP adopted in this
SSID can be turned in to Bridge Client mode by click the Bridge button.
Select a time policy to be applied to all clients connected to this SSID.
Choose Blacklist/Whitelist
excluded/included from connecting to the zone's Wi-Fi.
Default is Disabled.
Client isolation feature blocks any TCP/IP connection between connected
clients to GWN7610/GWN7600/GWN7600LR's Wi-Fi access point.
Client isolation can be helpful to increase security for Guest
networks/Public WiFi.
Three modes are available:
 Radio Mode: Wireless clients can access to the internet services,
GWN7xxx router and the access points GWN7610/GWN7600 and
GWN7600LR but they cannot communicate with each other.
 Internet Mode: Wireless clients will be allowed to access only the
internet services and they cannot access any of the management
services, either
GWN7610/GWN7600/GWN7600LR.
 Gateway MAC Mode: Wireless clients can only communicate with
the gateway, the communication between clients is blocked and
they cannot access any of the management services on the
GWN7610/GWN7600/GWN7600LR access points.
This field is required when using Client Isolation, so users will not lose
access to the Network (usually Internet). Type in the default LAN
Gateway's MAC address (router's MAC address for instance) in
hexadecimal separated by ":". Example: 00:0B:82:8B:4D:D8
GWN7610/GWN7600/GWN7600LR User Manual
Version 1.0.8.18
to specify MAC
on the router nor the
addresses to be
access points
P a g e | 53