Grandstream Networks GWN7600 User Manual page 45


40MHz Channel Location: Configure the 40MHz channel
location when using 20MHz/40MHz in Channel Width, users can
set it to be Secondary below Primary, Primary below Secondary
or Auto.

Channel: Select Auto, or a specified channel, default is Auto.
Note that the proposed channels depend on Country Settings
under System SettingsMaintenance.

Enable Short Guard Interval: Check to activate this option to
increase throughput.

Active Spatial Streams: Choose active spatial stream if Auto, 1
or 2 streams.

Radio Power: Set the Radio Power, it can be Low, Medium or
High.

Custom Wireless Power(dBm): allows users to set a custom
wireless power for both 5GHz/2.4GHz band, the value of this field
must be between 1 and 31.

Allow Legacy Devices(802.11b): Check to support 802.11b
devices to connect the AP in 802.11n/g mode.

Dynamic Channel Assignment: Once enabled, AP will try to
allocate and move the best channel during operation, unlike Auto
Channel Selection (ACS) which scan and assign channel when
WiFi interface goes up for one time. This feature is not supported
on GWN7610.

Transmit Power Control: TPC algorithm runs every 10 minutes.
AP acquires the RSSI information of the neighbor by wireless
scanning and establishes the neighbor table. The algorithm
requires that there must be at least 3 neighbor APs with RSSI
larger than -70dbm. Otherwise, power will not be adjusted.

Coverage Hole Detection: CHD enables AP to decide whether
to increase the AP power by the current SNR and SNR threshold
of the connected clients.
GWN7610/GWN7600/GWN7600LR User Manual
Version 1.0.8.18
P a g e | 45