Advertisement
Quick Links
Visual Quick Start Guide
HI99164
Hanna Instruments reserves the right to modify the design, construction,
or appearance of its products without advance notice.
Meter Setup
ON/OFF/MODE Button
6
sec.
SET/HOLD Button
Freeze Display
3
sec.
QR99164 10/15
Care and Maintenance
Electrode Cleaning
•
Soak the electrode in HI700643P electrode cleaning
solution for approximately 15 minutes to dissolve
deposits and other coatings. After cleaning, place in
storage solution for 1 hour before use.
15
min.
HI700643P
Pressing the
electrode
ON/OFF/MODE
cleaning solution
button after
buffer selection
Electrode Storage
returns to
measurement
•
After use, rinse the electrode with water and replace
mode.
the protective cap filled with a few drops of HI70300
storage solution.
DO NOT USE DISTILLED OR DEIONIZED WATER FOR
STORAGE PURPOSES.
HI70300
storage
solution
Battery Replacement
To replace the batteries:
•
Open the battery compartment cap (on the bottom of
the instrument).
•
Remove old batteries.
Press any button
•
Replace new batteries, observing the polarity.
to return to
•
Close the battery compartment cap.
measurement
mode.
1
hour
HI70300
storage
solution
Advertisement
Related Manuals for Hanna Instruments HI99164
Summary of Contents for Hanna Instruments HI99164
-
Page 1: Meter Setup
Press any button • Replace new batteries, observing the polarity. to return to • Close the battery compartment cap. measurement mode. Hanna Instruments reserves the right to modify the design, construction, or appearance of its products without advance notice. sec. QR99164 10/15... - Page 2 pH Calibration † For two-point calibration using pH 7 buffer go to procedure A For one-point calibration using pH 4, pH 7, or pH 10 buffer go to procedure B sec. † The probe tip should be rinsed with purified water (reverse osmosis, distilled, or deionized) before and after placing in any solution (buffer, storage or sample).