Table of Contents
Advertisement
W IL
INSTALLATION
GB
Bury the anchorage base provided (Fig. 8) in a cement foundation. This anchorage
o base must be flush with the foundation and peffectly level; also make one or
more, passageways for electric cables.
1) Stand the cubicle on the already installed base and anchor it with the screws and
washers provided.
2)Mount the bar using the connection provided and lock it with the 4 screws.
Cutany excess bar off.
3) The vertical and horizontal precision of the bar when it is open or closed can be
adjusted via the shock absorbers with stop (see the Adjustments chapter on page 8).
NB. Standard bars guarantee a net opening of 4 meters (WIL 4) and 6 metres (WIL
6) and we recommend using a support for the bar, espec!ally when the distance is
greater than 4 metres.
中文
将１～２根的线管穿过底板的线缆孔，调整安装底板至最佳水平
位置，用水泥把底板牢牢固定好（见图．８）
用螺丝和垫片把箱体固定在安装好的底板上；
1)
mitgelieferten Schrauben und Unterlegscheiben blockieren.
将栏杆多余的部分裁断至最佳长度，用螺丝把栏杆装在
2)
箱体上；
栏杆起降的垂直和水平精度可通过缓冲器调节（详见第
3)
８页调节器部分）；
注意 ： 型号ＷＩＬ４和ＷＩＬ６的标准栏杆长度分别为４Ｍ和６Ｍ。
我们建议做一支架支撑栏杆，特别是当栏杆的长度大于４Ｍ
时；
6
图８
图９ F
图１０
图１１ F
Hide quick links:
Advertisement
Table of Contents
