Cleaning The Brushroll; Checking The Nozzle For Blockages - Shark DuoClean NV800ANZMN Owner's Manual

MAINTENANCE - CONT�
TIP: You can also
check for blockages
in the hose and tubes�
Just remove the floor
nozzle, dust cup,
and hose and shine
a flashlight in the
openings�

CLEANING THE BRUSHROLL

1
Press down on the two buttons on the floor nozzle
to pop up the brushroll garage lid�
2 Lift the brushroll out by the tab on the left side�
To remove any string, hair or debris that may be
wrapped around the brushroll, use the onboard hair
removal tool� The tool is located in a compartment
on the nozzle, above the brushroll�
3 To reinstall the brushroll, return it to the brushroll
garage� Press down on the brushroll garage lid until
it clicks into place�
19
AUS 1800 099 385 NZ 0800 112 660
SOFT ROLLER
1
Slide the Soft Roller access button up
to remove the Soft Roller�
2 Use the onboard hair removal tool
to remove any string, carpet fibers
or hair that may be wrapped around
the Soft Roller� The tool is located in
a compartment on the nozzle, above
the brushroll� You can also tap loose
debris off the Soft Roller, or wipe it
clean with a dry towel� If you see any
fibers or hair buildup in the teeth
behind the Soft Roller, take a dry towel
and wipe it away�
AU S s h a r kc l e a n . c o m . a u
3 Wash the Soft Roller as needed� Use
only water, and let air-dry completely
for at least 24 hours�
4 Reinsert the Soft Roller by sliding it
into the front of the nozzle until it
clicks into place�

CHECKING THE NOZZLE FOR BLOCKAGES

1
Tilt neck of nozzle back to straighten
the airway�
N Z s h a r kc l e a n . c o . n z
20