Penn Elcom PDU16-6UK User Manual

PDU16-6UK
20A AC STAGE & TRUSS MOUNT PLUG BOARD
Neutrik 20A 240V Blue
PowerCON input connector
For the full 20A usage the
right cable & supply
source should be used
Fitting a 13A plug will
de-rate this board
LINK OUTPUT is a grey 20A
PowerCON output connector
and is directly coupled
to the Power Input Socket
not via the breaker circuit
For safety it must be remembered when using the LINK output that the
combined load of the 'Daisy Chained' units should not exceed 20A.
If the switch is in the reset position
1st check the power is connected &
POWER INPUT SIDE
LINK OUTPUT SIDE
USERS GUIDE
RED Neon Indicator
and lit - this shows there should
be AC power to the board.
Should these Not be Lit then -
none of the outputs are being
overloaded
16A Trip Switch
for the 6 UK sockets
in the event of overload
this will cut the power