Mitsubishi FX2N-32CCL-NP Hardware Manual

This manual contains text, diagrams and explanations which will guide the reader in the correct installation
and operation of the FX
understood before attempting to install or use the unit. Further information can be found in the FX series
PLC hardware manuals.
Guidelines for the safety of the user and protection of the FX
SYSTEM LOCAL BLOCK
• If in doubt at any stage during the installation of the FX
BLOCK always consult a professional electrical engineer who is qualified and trained to the local
and national standards. If in doubt about the operation or use of the FX
SYSTEM LOCAL BLOCK please consult the nearest Mitsubishi Electric distributor.
• Under no circumstances will Mitsubishi Electric be liable or responsible for any consequential
damage that may arise as a result of the installation or use of this equipment.
• All examples and diagrams shown in this manual are intended only as an aid to
understanding the text, not to guarantee operation. Mitsubishi Electric will accept no
responsibility for actual use of the product based on these illustrative examples.
• Owing to the very great variety in possible application of this equipment, you must satisfy
yourself as to its suitability for your specific application.
Note's on the symbology used in this manual
At various times through out this manual certain symbols will be used to highlight points of information
which are intended to ensure the user's personal safety and protect the integrity of the equipment.
Whenever any of the following symbols are encountered, its associated note must be read and
understood. Each of the symbols used will now be listed with a brief description of its meaning.
Hardware warnings
1) Indicates that the identified danger WILL cause physical and property damage.
2) Indicates that the identified danger could POSSIBLY cause physical and property damage.
1. INTRODUCTION
The FX -32CCL-NP is the interface block that connects the FX series PLC to the CC-Link system.
2N
It is connected as a local station.
Master station ................. Station which controls the remote I/O station, remote device station, and local
Remote I/O station .......... Remote station which handles only on/off data
Remote device station .... Remote station which handles both on/off data and numeric data
Local station.................... Station which has a CPU and can communicate with the master station and
M a s t e r S t a t i o n
F X P L C
2 N
P r o g r a m c a b l e
Industrial automation
Elincom Group
FX
-32CCL-NP CC-Link SYSTEM LOCAL BLOCK. It should be read and
2N
stations
other local stations
A J 6 5 B T - G 4
C C - L i n k
F X P L C
2 N
F X - 3 2 C C L
2 N
- N P
P r o g r a m
European Union: www.elinco.eu
Russia: www.elinc.ru
-32CCL-NP CC-Link SYSTEM LOCAL BLOCK
2N
HARDWARE MANUAL
-32CCL-NP CC-Link SYSTEM LOCAL
2N
P r o t o c o l i n t e r f a c e
F X - 2 3 2 A W C - N P
2 N
R S - 4 2 2
F X - 3 2 C C L - N P
2 N
c a b l e
JY992D96001A
-32CCL-NP CC-Link
2N
-32CCL-NP CC-Link
2N
P r o g r a m m i n g
s o f t w a r e
R S - 2 3 2 C
P o w e r s u p p l y
R e m o t e I / O s t a t i o n