Cleaning; Harvest Container; Problems, Causes And Solutions - BERG BENOMIC Series Technical Handbook

8.5

Cleaning

Remove any plant remains, leaves etc and brush off any sand and dust, on a regular basis.
Clean the Pipe Rail Trolley with a dry/damp cloth or soft brush. Provided it is completely dry, the
BENOMIC can be cleaned using compressed air. Never pour water over the BENOMIC or clean
it using a steam or high-pressure water cleaner which can lead to serious damage to the
electrical circuits!
Every week sand and dirt should be removed from the chassis for the scissor sliding block.
See also Appendix 4: Cleaning the powder coating
8.6

Harvest container

As an optional extra for the BENOMIC model with the heavy duty double scissor, a harvest
container is available that can be put onto the platform in combination with top end controls and
a sliding rack. The harvest container along with its accessories (rails/sliding rack, etc) must only
be supplied by Berg Hortimotive The harvest container serves as a buffer for harvesting
peppers. The maximum load capacity of the platform should be reduced by the weight of the
container and the sliding rack. The maximum loading capacity of 450/550kg must never be
exceeded!
8.7

Problems, causes and solutions

Problem A :
Cause : Key switch is OFF
Solution : Turn on the key switch (vertical position)
Translated user manual (EN-V11)
The BENOMIC does not move
Emergency stop locked on
Unlock the emergency stop button (pull out)
Batteries flat
(red leds 2x flashing on battery condition indicator)
Charge up the batteries with the charger
Speed indicator at 0
Set a speed
Direction of travel at 0 or inconsistent
Set direction of travel (or equivalent)
Error status (leds flashing intermittently)
See no 4 on page 21
Battery terminals making poor contact
Clean and re-tighten battery terminals
Faulty foot switch
Replace foot switch - consult your dealer
Broken cable at foot switch
Repair cable break or replace switch
Lift does not fully collapse or limit switch is defective
Collapse lift system completely (10) or check switch
25 amp safety fuse in 0 position.
Consult your dealer
Other causes.
Consult your dealer
BENOMIC
 25 / 43