BERG BENOMIC Series Technical Handbook page 9

Table of Contents

Advertisement

-
Never leave the BENOMIC unattended.
-
Unless the key has been removed from the main switch.
It is forbidden to carry out modifications/alterations to the BENOMIC without receiving
-
prior written consent from Berg Hortimotive
Before travelling along the pipe rail track always check that there are no persons in the
-
immediate vicinity.
-
It is forbidden to transport loose cargo with the BENOMIC.
-
Stack the loads in such a way that they reach no higher than 40cm above the work
platform. All loads should be properly secured.
Before using a track, ensure that it is clear of obstacles such as plant remains etc.
-
-
Never clean the BENOMIC using a water hose, high pressure spray or steam equipment.
-
Other than when on the pipe rails, the scissor should be fully collapsed before moving the
BENOMIC.
Never use the BENOMIC on public roads or paths.
-
It is forbidden to step off the equipment before it is in the lowest position.
-
-
Follow the safety instructions for the batteries - see Appendix 3.
Think about your feet and toes when operating the lift on the BENOMIC! The trolley is
-
positioned a few centimetres in front when setting down!
It is mandatory to wear footwear with steel toe caps (S1).
-
-
Remove the charging plug before operating the BENOMIC.
-
After use, the direction of travel switch should always be set at neutral.
Attention!
-
Always keep the working area tidy.
- An untidy working area can lead to dangerous situations.
-
Always concentrate on the task in hand.
- Remain alert at all times when operating the Pipe Rail Trolley. Do not use the BENOMIC if you re
unable to concentrate or are taking medicine that advises against operating machines or driving a
motor vehicle.
Translated user manual (EN-V11)
BENOMIC
 9 / 43

Advertisement

Table of Contents
loading

Table of Contents