Table of Contents
Advertisement
8.4.3
Ready for use
To make the machine ready for use, the 4 stabilizers must be fully retracted. Use the
handwheels (D) to retract the stabilizers completely. Release the locking pins of the
stabilizers (A). Slide the posts vertically, completely upwards (E), check if the stabilizer
feet rotate in the vertical position. Fix the stabilizers with the locking pins (C) in the locking
holes to prevent unintentional movement of the stabilizers.
Automatically disconnect "sleep mode"
8.5
The BENOMIC S500 is equipped with an automatic shut-off function to save energy when
you forget to turn off the trolley at the main switch (1).
After one hour of no operation, the BENOMIC S500 will automatically enter "sleep mode",
the signal lamp (11) and the battery condition meter (13) will no longer be illuminated.
Remove the BENOMIC S500 from this function by briefly pressing the HORN / RESET
button (2 or 10) (see also 1. MAIN SWITCH / EMERGENCY STOP)
Attention!
- The BENOMIC S500 is in "sleep mode" not switched off!
- Never leave the BENOMIC S500 unattended when the key is still in the main
switch!
8.6
Out of service
If the BENOMIC S500 is out of service, make sure the platform is in the lowest position
and the lift-wheels are retracted so that the trolley stands on its flange rollers. Always
switch off the machine, using main switch and remove the key. Store it with charged
batteries in a moisture-free and frost-free room. It is recommended to connect the
batteries on the BENOMIC S500 to a trickle charger. Otherwise, the batteries should
always be charged at least monthly (even if the BENOMIC S500 remains stationary for a
long time). Provide a level surface and protect the trolley from direct sunlight. If the
BENOMIC S500 is put back into operation after a longer period in storage, it must first be
inspected as described in section 7.1 (Inspection before starting operations).
8.7
Cleaning
Regularly remove any remains of plants, leaves, etc. and brush off any sand and dust.
Clean the pipe-rail trolley with a dry/damp cloth and soft brush. If it is dry, you may clean
the BENOMIC S500, with compressed air. Never pour water over the BENOMIC S500
and/or clean the machine using a steam or high-pressure water cleaner, as this can cause
serious damage to the electrical circuits
Every week, remove sand and dirt from the frame at the level of the scissor-slide blocks.
See also Appendix 4. Cleaning the powder coat finish
Translated user manual (EN-V1)
BENOMIC S500
37 / 57
Advertisement
Table of Contents
