Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Fulham HotSpotLED FHSAC1-UNV-70S
Summary of Contents for Fulham HotSpotLED FHSAC1-UNV-70S
- Page 1 INSTALLATION INSTRUCTIONS for a full charge Page 1 of 6...
- Page 2 Factory Default Settings: Normal Output Current: 350mA EM Power:6W(0℃-50℃) Self-Diagnostics: Enable 3W to 7W (Programmable) Page 2 of 6...
- Page 3 INSTALLATION INSTRUCTIONS Guideline on calculating emergency illumination level The purpose of this guideline is to identify the illumination level of the LED luminaire when used with Fulham's FHAC1-UNV-70S LED emergency driver. The path of egress illumination level during emergency operation is determined by types of luminaires, Luminaire Efficacy, Luminaire Mounting Height, Emergency Power and...
- Page 4 BATTERY REPLACEMENT/SERVICING INSTRUCTIONS Warning: Disconnect power when servicing fixture. Unscrew the nut Remove battery cover and pull out wiring Disconnect the connector Take out a new battery Re-connect the battery connector and place all wires back into the battery cover Completed Assembly SAVE THESE INSTRUCTIONS Page 4 of 6...
- Page 5 SELF-DIAGNOSTIC INSTRUCTIONS / OPERATION: If the self-diagnostic feature is enabled: The emergency LED driver will conduct a self-check for thirty(30)seconds every thirty(30)days; and a ninety(90) indicator status chart above to diagnose the status signal. , Check LED connection replace driver 3.
- Page 6 Page 6 of 6...
Need help?
Do you have a question about the HotSpotLED FHSAC1-UNV-70S and is the answer not in the manual?
Questions and answers