Description Of Error Code; Abnormality Detection For Deck Mechanism; Abnormality Detection For Cd/Changer Block; Power Supply Related Error Detection - Panasonic SA-VK31EE Service Manual

SA-VK31EE

11 Description of Error Code

11.1. Abnormality Detection for DECK Mechanism

No. Error
1 MODE SW abnormal
2 REC INH SW abnormal
3 HALF SW abnormal
4 abnormal

11.2. Abnormality detection for CD/Changer Block

No. Error
1 REST SW abnormal
2 Transmission error between CD servo
LSI and micon
3 CLAMP SW abnormal
4 BOTTOM SW abnormal
5 POSITION SW abnormal
6 SW1 abnormal
7 SW2 abnormal
8 OPEN SW abnormal

11.3. Power Supply Related Error Detection

No. Error
1 POWER AMP output abnormal
Error Display Problem condition
H01 Normal operation during mecha transition, MODE SW abnormal is
memorized. The content of abnormality can be confirmed in the
abnormal detection mode explained in the later section.
H02 The content of abnormality can be confirmed in the abnormal detection
mode explained in the later section.
H03
F01
Error Display Problem condition
F15 Under normal operation (Self-Diagnostic Mode inclusive), this error
occurs when the RESTSW ON is not detected within the specified time
and shall be memorized.
F26 Under normal operation (Self-Diagnostic mode inclusive), this error occurs
when the selection is set to CD and SENSE="H" is detected and
SENSE="L" is not detected within a fail safe time (20ms) after system
command transmission was sent.
F16 Refer to CR20 control specification section 5-2 [ERROR CODE] table M-
0A error is detected.
F17 Refer to CR20 control specification section 5-2 [ERROR CODE] table M-09
error is detected.
F27 Refer to CR20 control specification section 5-2 [ERROR CODE] table M-05
~ M-08 error is detected.
F28 Refer to CR20 control specification section 5-2 [ERROR CODE] table M-02
~ M-08 error is detected.
F29
H15 Refer to CR20 control specification section 5-2 [ERROR CODE] table M-01
error is detected.
Error Display Problem condition
F61 During normal operation, if DCDET 1/2 becomes "L", normal POWER
OFF process shall not ve executed, PCNT shall be switched to "L"
immediately. GOODBYE shall not be displayed and the error display F61
will be displayed instead.
2 seconds after the F61 display, ECONO shall be set to "L" and FL
display shall be turned off.
The error content shall be memorized when the abnormality occurs and
can be displayed in the C-mecha self-diagnostic mode described later.
36