Dvd/Cd Self-Diagnosis Error Code Description; Error Codes Stored During No Play; Mode Table - Panasonic SA-VK91DGCS Service Manual

SA-VK91DGCS / SA-VK91DGCP

15.4. DVD/CD Self-Diagnosis Error Code Description

Error Code
H15 The disc tray cannot be opened: it closes spontaneously.
H16 The disc tray cannot be closed: it opens spontaneously.
Error Code
U. H. Error
U11 Focus servo failure
H01 Tray loading failure
H02 Spindle servo failure
H03 Traverse motor failure
H04 Tracking servo error
H05 Seek timeout failure
H06 Power supply error
DSC system
F500 DSC failure
F501 DSC not Ready failure
F502 DSC Time out failure
F503 DSC communication failure
F505 DSC Attention Error
F506 Invalid media
Disc Code
F103 Ilegal highlight position
IIC Error
F4FF Forced initialization failure (Time out)
F880 Unsuitable task number
F890 A message is sent during AV task transmission
F891 Unable to transmit a message to AV task
F893 DVD Module problem
F894 EEPROM failure
F895 Firmware compatibility problem
F897 Initialization is not done properly
F8A0 Unsuitable message command

15.5. Error Codes Stored During No Play

Error Code
F0BF 6) Unable to replay due to physical layer
identification failure
F0C0 8) DVD: Unable to replay due to no DVD
Video/Audio/VR
F0C1 9) DVD: Prohibited due to illegal regional
code
F0C2 A) DVD: No replay due to PAL system
F0C3 B) DVD: All title replay prohibited in parental
setting
F0C4 C) VCD: Prohibited due to PHOTO CD
format
F0C5 D) VCD/CD: Prohibited due to CD-ROM
without CD-DA

15.6. Mode Table 2

Following modes are available with combinations of the pressed buttons on the player and on the remote controller unit.
All manuals and user guides at all-guides.com
State, Conditon
Meaning
Meaning System Computer Item
PCND_NOPLAY_PHYSICAL 0x50 DriveManager
PCND_NOPLAY_VIDEO 0x70
PCND_NOPLAY_RCD 0x80
PCND_NOPLAY_PAL 0x90
PCND_NOPLAY_PTL 0xA0
PCND_NOPLAY_PHOTOCD 0xB0 DiscManager
PCND_NOPLAY_CDROM 0xC0
Cause, Troubleshooting
Disc tray open/close detection switch (S1001) failure.
(Check and replace)
(Spindle servo, DSC, SP motor, CLV servo failure)
DSC stops due to servo failure.
(Startup, focus failure, etc.)
Communication failure between DSC and system computer
(No communication because DSC does not move)
See F500.
Communication failure (Result failure occurs after communication
command is transmitted.)
See F500.
Disc is placed upside down; TOC is unreadable or invalid disc is
inserted.
Disc standard is possibly illegal when highlight is displayed.
When a message arrives from not existing task
During transmission of a message to AV task
When transmission of a message to AV task starts
Check for firmware version
Check for firm version for Main & DVD Module P.C.B.
Follow proper steps for initialization & reset
When transmission of a message to AV task starts
Setting Task
DiscManager
DiscManager
DiscManager
DiscManager
DiscManager
26
Details
Internal error in system
computer
0xD0BF
0xD0C0
0xD0C1
0xD0C2
0xD0C3
0xD0C4
0xD0C5