Figure 3-1. Installing the Graphics Controller Modules
Completing the Installation
To complete the installation:
1. Close the workstation.
2. Connect the monitor video cable to the blue video output port on the
graphics rendering module of the PowerStorm 600 graphics controller.
If a workstation monitor has no built-in video cable, use a shielded video
cable with a 15-pin (D-sub) video connector at one end for the video output
port on the controller and the appropriate connectors at the other end for
the video input port on the workstation monitor.
Compaq Confidential – Need to Know Required
Writer: Carmen Wheatcroft Project: Compaq PowerStorm 600 Graphics Controller Hardware Guide Comments:
Part Number: 120259-XX1 File Name: d-ch3 Installing the Hardware.doc Last Saved On: 2/19/99 9:01 AM
Installing the Hardware 3-3
ML014886