Table of Contents
Advertisement
4-2 Compaq PowerStorm 600 Graphics Controller Hardware Guide
Writer: Carmen Wheatcroft Project: Compaq PowerStorm 600 Graphics Controller Hardware Guide Comments:
Part Number: 120259-XX1 File Name: e-ch4 Installing the Software.doc Last Saved On: 2/19/99 9:01 AM
3. Click the Display icon in Control Panel. The Display Properties menu
appears.
4. Click the Settings tab.
5. Click the Display Type button and bring up the Display Type panel.
6. Click the Change button and bring up the Change Display panel.
7. Click Have Disk and bring up the Install From Disk panel.
8. In the Install From Disk panel, enter the path for your driver. Click OK.
9. Verify that the Intense 3D Wildcat 4000 driver is highlighted in the
Change Display dialog, and click OK.
10. Click Yes when asked if you want to install a third-party driver.
The driver files on the CD are copied to the primary hard drive of your
workstation.
11. Insert the CD if you are prompted to do so and click OK.
The installation will continue copying files. After the driver files are copied
successfully, a message that the driver successfully installed displays.
12. Click OK again.
13. Click Close to exit the Display Type dialog.
14. Click Close to exit the Display Properties dialog.
15. When informed that the workstation must be restarted for the new
settings to take effect, remove the CD from the CD-ROM drive and
click Yes to restart the workstation.
After the system restarts and you log in, a message displays. The message
states that a new graphic driver has been installed, and that you should use
the Display option in the Control Panel to select the preferred display
resolution.
16. Click OK.
17. The Display Properties/Settings panel is brought up. Click OK to have
the current settings applied.
18. If you want to change the display resolution or other display settings,
see the following section, "Configuring the Video Display."
Compaq Confidential – Need to Know Required
Advertisement
Table of Contents
