Red Technology MAGIC-2 Instruction Manual page 12

Key
STOP
(in engraving state)
START
( in positioning state)
VISE IN/OUT
(in stand-by state)
MOVE
( in positioning state)
If the machine is in engraving state, pressing this button will cancel
engraving. Stopping the engraving job, it will return to home position.
If the machine is in engraving area positioning state, press this button
for more than 1 second to start engraving.
I f the machine is in stand-by state, press this button to pull the in in and
out.
If the machine is in engraving area positioning state, pressing this
button will move engraving position to the left/right/top/bottom in
accordance with current position.
11