Section 4 - Repair And Adjustments; Auger Drive Belt Adjustment - Snapper LE3171R, LE3191R, LE3191E Safety Instructions & Operator's Manual

Section 4 - REPAIR & ADJUSTMENTS
WARNING
DO NOT attempt any adjustments, maintenance,
service, or repairs with engine running. Stop auger.
Stop engine. Remove key. Remove spark plug wire
and secure wire away from spark plug.
4.1 AUGER BELT ADJUSTMENT/REPLACEMENT
When operating machine release the auger clutch
control. The auger should come to a complete stop in
5 seconds. If the auger does not come to a complete
stop in the required time, check and adjust belt
tension. Inspect belt frequently for signs of excessive
wear. Observe drive belt for slippage due to wear
when operating machine. If slippage does occur
adjust as follows.
4.1.1. AUGER BELT CABLE ADJUSTMENT
1. Measure control cable extension from a relaxed
position to full extended position. Move control
lever against handle. Measure the overall length of
the spring. The length of the cable spring should
increase by 1/2" to 3/4" when the clutch control is
depressed. See Figure 4.1.
CABLE SPRING
SHOULD EXTEND
1/2" TO 3/4"
RELAXED
JAM
NUT
CABLE
HOUSING
FIGURE 4.1
2. Loosen jam nut at the upper end of cable. Hold
threaded end of cable and then turn cable clockwise
until correct extension is achieved. Retighten jam nut.
IMPORTANT: DO NOT over tighten cable. The control
cable must have slack for the auger brake to function
properly. If the auger control cannot be properly
adjusted, belt adjustment and/or replacement will be
required. Refer to Section "Auger Belt Idler Pulley
Adjustment".
AUGER CLUTCH
CONTROL
UPPER
HANDLE
EXTENDED
4.1.2. AUGER BELT IDLER PULLEY
ADJUSTMENT
NOTE: To adjust the idler pulley and properly tension
the auger belt, the auger control cable adjustment
must first be loosened as described in the following
step. Cable adjustment must be checked after
completing the idler pulley adjustment.
1. Loosen jam nut at the upper end of cable. Hold
threaded end of cable and then turn metal housing of
cable counter clockwise until threaded portion of
cable is extracted from metal housing. Reinstall 1/2"
of the threaded portion of cable back into metal
housing. Retighten jam nut.
2. Remove belt cover. See Figure 4.2
REMOVE COVER FOR
IDLER PULLEY
ADJUSTMENT
(Continued on the Next Page)
12
FIGURE 4.2