Section 3 - MAINTENANCE
3.4 ANNUALLY (END OF EACH SEASON)
Perform
all
maintenance
maintenance schedule.
3.4.1. Engine
Refer to engine owner's manual for service
instructions.
3.4.2. Spark Plug
Refer to engine owner's manual for service
instructions.
3.5 STORAGE PROCEDURE
Refer to the Engine Owner's Manual for directions
regarding engine storage preparations. Prepare the snow
thrower for "end of season" storage as follows:
1. Drain fuel from fuel tank and let engine run until
all fuel is out of the carburetor.
2. Disconnect and remove the spark plug wire
away from
spark
preparations are made!
3. Tape all openings closed to prevent spraying
water into exhaust or air intakes during washing.
4. Tilt snow thrower up on its wheels and
thoroughly
clean
auger/impeller.
5. Lubricate all exposed metal with a light coating
of oil to prevent corrosion.
6. Store the machine in a shed or other dry area,
protected from weather.
3.6 MAINTENANCE and SERVICE PARTS
as
described
plug
before any other
the
underside
of
MAINTENANCE and SERVICE PARTS
Auger Drive Belt (Briggs Engines)
Auger Drive Belt (Tecumseh Engines)
Wheel Drive Belt (Briggs Engines)
Wheel Drive Belt (Tecumseh Engines)
Scraper Blade (24" Width Auger)
Scraper Blade (26" Width Auger)
Scraper Blade (30" Width Auger)
Rubber Drive Tire
Shear Bolts - 5/16-18 x 1-7/8"
Hex Nuts - 5/16-18
Parts Manual for Large Frame Snow Throwers - Series 6
Models: 8246, 9266, 9266E, 11306
in
the
the
12
1-3937
1-3939
1-3936
2-9101
3-6122
3-9770
3-6006
1-0765
9-1550
9-1298
#06069