Maximum Rinse Level; Suds Cooling; Low Water Pressure; Anti-Crease - Miele WWF 060 Operating Instructions Manual

Maximum rinse level

The water level in the rinse can be
permanently set to the highest value.
This function is important for allergy
sufferers as it achieves excellent wash
results. The water consumption will be
increased.
The function is switched off in the
factory setting.

Suds cooling

Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a
Normal program with a temperature of
70 °C or higher is selected.
Suds cooling should be activated:
– To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
– Where the drainage pipes do not
comply with DIN 1986.
Suds cooling is switched off in the
factory setting.

Low water pressure

If the water pressure is below
14.5 psi/100 kPa, the program will be
cancelled and the fault message
Drainage See 
If the on-site water pressure cannot be
increased, activating this function will
prevent the program from being
cancelled.
Low water pressure is switched off in
the factory setting.

Anti-crease

The Anti-crease function reduces
creasing after the end of the program.
At the end of the program, the drum
continues to turn at intervals for up to
30 min. The washing machine door can
be unlocked and then opened at any
time by touching the Start/Stop sensor
button.
Anti-crease is switched on in the factory
setting.
Settings
will appear.
81