Display switch-off
The display and the sensor button
lighting is switched off to save energy.
The Start/Stop sensor button flashes
slowly.
Options
–
On
Lighting switches off after 10
minutes.
–
On (not crnt prog)
Lighting remains switched on
throughout the program. The lighting
switches off 10 minutes after the
program has ended.
–
Off
The lighting remains switched on.
Program info
You can select the information that will
be displayed temporarily once a
program has been selected in the
display.
Options
–
Program name
(factory setting)
The program name is shown in the
display for several seconds.
–
Prog. nm. & max ld.
The program name and the maximum
load are shown in the display for
several seconds.
–
Off
Directly after the program has been
selected, the standard display is
shown with temperature, spin speed,
and program duration.
(factory setting)
Memory
The washing machine will save the
last settings (temperature, spin speed
and some of the Options) selected for
a program after the program has
started.
When the program is chosen again, the
saved settings will appear in the
display.
The memory function is switched off in
the factory setting.
Water intake
You can program 3 options for the
water inlet. The water inlet is
controlled by the two inlet hoses.
Options
–
Cold water
The washing machine will be
operated with cold water only.
–
Hot water
(factory setting)
Hot water is used in the main wash to
save energy.
You can heat up your water with
cheaper, primary energy sources, e.g.
gas, solar power, oil. The temperature
must be below 60 °C.
For technical reasons, the
washing machine must always be
connected to cold water.
Settings
79