OWC Mercury Elite Pro Mini Assembly Manual & User Manual page 7

4
5
6
7
OWC Mercury Elite Pro mini
4. Note the SATA connector on the inner chassis (highlighted in
yellow). There are also four screw holes circled in red — two
through the metal chassis on the right and two through the
circuit board and chassis on the left.
5. Place the drive in the inner chassis as shown, then slide the drive
into the SATA connector on the circuit board. Make sure the drive
is fully seated before proceeding.
6. Use one hand to hold the drive in place, then turn over the inner
chassis. Note the four screw holes with rubber grommets, circled
in red.
7. To affix the drive to the inner chassis, insert the four screws
(included) into the screw holes, then fasten them using a Phillips
driver. When this is done, turn over the inner chassis.
5
Device Setup