Table of Contents
Advertisement
Install Push Bar
1. Drive the tractor over the push bar until the rear of the
push bar is positioned between the side rail exten-
sions on the front of the hitch.
2. Stop engine, remove key and set parking brake.
3. See Figure 15. Align the mounting holes in the rear
corners of the push bar (A) with the mounting holes in
the hitch (B), and secure the push bar to the hitch
with a clevis pin (C), and safety clip (D) at each cor-
ner.
4. See Figure 16. Insert front of push bar (A) into pivot
frame (B) on rear of blade. Then install the pivot pin
(C) down thru front holes in hitch and pivot frame.
Secure with spring clip (D).
D
Figure 15.
A. Push Bar
B. Hitch
Figure 16. Dozer Blade Assembled and Installed
A. Push Bar
B. Pivot Frame
13
Initial Setup & Assembly
B
A
C. Clevis Pin
D. Safety Clip
(Not shown)
C. Pivot Pin
D. Spring Clip
C
Advertisement
Table of Contents
