Simplicity 1693706 Installation Instructions Manual

54”turbo blower

Advertisement

Quick Links

Installation
Instructions

SAFETY RULES

Read these safety rules, and the safety rules in
your tractor Operator's Manual, and follow them
closely. Failure to obey these rules could result
in loss of control of vehicle, severe personal
injury to yourself, or damage to property or
equipment. THE TRIANGLE
SIGNIFIES IMPORTANT CAUTIONS OR WARN-
INGS WHICH MUST BE FOLLOWED.
WARNING
● When blower assembly is removed from the mower
deck, the deflector must be properly installed.
● If the mower stalls or the turbo blower chute plugs,
disengage the electric clutch (PTO), stop the engine
and remove the key. set the parking brake. wait for
moving parts to stop. Remove the foreign object or
clear the chute with a piece of wood before restarting
the engine. Never place hands into blower housing to
clear jammed object. Blower may rotate when object
is removed.
● For added tractor stability and to prevent tipping or
loss of control:
a. Use reduced speed on uneven ground and when
turning corners.
b. Reduce loads on hillsides. It is recommended that
the collection system be kept only half full when
negotiating any slopes. Start mowing on slopes
when the collection system is empty.
c. Mow up and down the face of slopes; never
across the face of any slope.
● When operating on slopes, use front counterweight.
Never operate on slopes greater than 17.6% (10°).
● Know the tractor controls and how to stop quickly.
READ THE TRACTOR OPERATOR'S MANUAL.
● Disengage the electric clutch (PTO). Shut off the
engine, remove the key, and wait for all moving parts
to stop before attaching, adjusting, or disconnecting
any part of the collection system.
● Check the collection system to make sure it is bolted
tightly to the tractor.
● Look behind to make sure the area is clear before
backing up.
● DO NOT turn sharply when travelling alongside a
building or any object.
● DO NOT carry passengers on the tractor.
● Read and obey all warning decals.
OPERATION
IN THE TEXT
Operation With Turbo
• Grass should be cut often but not too short. If grass is
• Before mowing, clear the lawn of all sticks, stones,
• The blower housing should be removed for cleaning.
• Always operate at full throttle speed.
Operation Without Turbo
• For operation without the turbo, the deflector must be
• To remove turbo, reverse the installation steps.

Recommended Accessories

• Front counterweight is recommended when using
• On slopes over 17.6% (10°), use two rear wheel
Always mow up and down the face of slopes, never across
the face. Never mow on slopes greater than 30% (16.7
degrees)
NOTE: In these instructions, "left" and "right" are
referred to as seen from the operating position.
1
54"Turbo Blower
Mfg. No. 1693706, 1695299
WARNING
Read and obey all operation and warning decals.
WARNING
• Do not open cover with engine running.
• Do not operate mower without the
complete catcher in place
• When operating on slopes, refer to
operator's manual for counterweights.
DANGER
ROTATING CUTTING BLADE
Do not operate mower
without deflector or entire
grass catcher in place.
1704277
too long or lush, it may be necessary to keep ground
speed to a minimum or to cut only half the width to
prevent clogging. If grass is too high, operate with
mower in high cutting position. Cut the grass again in
lower cutting position, if desired.
wire and other debris which may be caught or thrown
by the mower blades.
If a large amount of cut grass is spilling out from
under the deck, the tube may be plugged or grass
bags are full. Shut off tractor, disengage the PTO,
remove the key, and allow all moving parts to stop
before disconnecting the tube.
properly installed in the down position and retained
by the spring latch.
rear-mounted grass catcher.
weights in addition to front counterweight.
For 54" Mower Decks
1704405
WARNING
• This shield must be
in place at all times
during operation.
• Mower deflector
must be in down
position when
blower is removed.
1717291

Advertisement

Table of Contents
loading

Summary of Contents for Simplicity 1693706

  • Page 1: Safety Rules

    ● When blower assembly is removed from the mower deck, the deflector must be properly installed. ● If the mower stalls or the turbo blower chute plugs, disengage the electric clutch (PTO), stop the engine and remove the key. set the parking brake. wait for moving parts to stop.
  • Page 2 Installation Instructions 20 19 54”Turbo Blower...
  • Page 3 54”Turbo Blower Kit Contents: Part No. Qty. Description 1665982 RETAINER, Bearing 108202 BALL BEARING 1931333 CARRIAGE BOLT, 5/16-18 x 3/4 1706631 FAN ASSY 1927557 FLANGE LOCKNUT, 5/16-18 1921332 CAPSCREW, .312-18X0.750 G5 1706634 PULLEY 960403 KEY, Woodruff 1960619 SET SCREW, Torx, 5/16-18 x 5/16...
  • Page 4: Initial Installation

    Figure 1. Install Hook Plate A. 5/16-18 x 3/4 Carriage Bolts B. Hook Plate C. Deck Shell D. Flange Locknuts E. Clips Figure 2. Install New Arbor Pulley A. Capscrew B. Lockwasher Assy. 54”Turbo Blower Stone Guard C. Washer D. Pulley and Hub...
  • Page 5 54”Turbo Blower Figure 3. Install Cover & Spring Anchor A. Taptite Screw D. Roller Bar Retainer B. Spring Anchor E. New Arbor Cover Assy. C. Cover Clip Install Deflector 1. Locate the taptite screw (A, Figure 3) securing the inner right-hand belt cover spring clip (C). Remove the taptite screw (A).
  • Page 6 B. 1/4-20 x 1-1/4 Carriage Bolt C. Hinge & Deflector (Deflector Removed for Clarity) D. Tapered Spacer E. Original Lockwasher and Nut F. 5/8 x 1 Cylinder Spacer Figure 7. Connect Deflector Spring A. Spring Anchor B. Spring C. Deflector Arm 54”Turbo Blower Tapered Spacer...
  • Page 7: Install Turbo Blower

    C. Spring Clips F. Spring Install Turbo Blower 1. Install the turbo blower assembly. Insert the tapered spacers (B, Figure 8) through the bottom of the blow- er housing (A). 2. Install one spring clip (C) on both tapered spacers (B).
  • Page 8: Installation

    REMOVAL Installation 1. Insert the tapered spacers (B, Figure 11) through the bottom of the blower housing (A). 2. Install one spring clip (C) on each of tapered spacers (B). 3. Hook the bottom of the turbo on the bottom hook bracket.

This manual is also suitable for:

1695299

Table of Contents