Maintenance; Faults And How To Remedy - Wolf Garten Campus 250 RT Original Manual

Maintenance

Replacing the cord spool
1
The trimmer continues to spin after
being switched off! Always disconnect
from the power supply before perform-
ing any work on the trimmer!
1. Press both locking tabs of spool cover simulta-
neously and remove

Faults and how to remedy

Problem Ursache
• Spool is empty.
• Dirt and debris in spool drive mechanism. • Clean parts with a brush.
Automa-
• Line is torn and stuck inside spool.
tic line
feed me-
• Line is „welded" to itself or to spool
chanism
through heat build-up.
is not
working.
• Line is „welded" to itself or to spool
through heat build-up.
When in doubt, always consult a WOLF service workshop.
G
J K
2. Remove cord spool
3. Clean, if necessary
4. Insert cord spool into housing
5. Place the spool cover on the cord spool holder
so that the two locking tabs lock into place
1
Before switching on: Hold trimmer paral-
lel to the ground; otherwise, there is dan-
ger of injury.
Abhilfe
• Fit new spool (GT-RT, 6070 096).
• Remove spool, check tightness of winding
and replace spool in the usual way.
• Remove welded line section, check tight-
ness of winding and replace spool in the
usual way.
• Remove welded line section, check tight-
ness of winding and replace spool in the
usual way.
L
M
.
N
.
14