Mitsubishi Electric Mr.Slim PLA-A24EA7 Service Manual page 40

OPERATING PROCEDURE
8. Removing the fan motor (MF)
(1) Remove the turbo fan. (See Photo 6 and refer to
procedure 7.)
(2) Remove the lead cover (tapping screw 4×10: 2 screws).
(See Photo 9.)
(3) Loosen the 2 clamps.
(4) Remove the 3 washer nuts (M5).
(5) Remove the fan motor.
(6) Remove the 3 rubber mounts.
Figure 3
Cross section diagram
Fan motor
Rubber mount
Note: When re-attaching the motor mount, make sure
that the thicker end faces the motor shaft.
9. Removing the panel
(1) Remove the electrical box fixing cover. (See Photo 1.)
(2) Disconnect the connector for vane motor (CNV: White).
(Refer to procedure 5.)
(3) Loosen the 4 corner panel fixing screws (tapping screw
4×16). (See Figure 4.)
(4) Slide the corner panel to the direction of the arrow 1,
and remove the corner panel. (See Figure 4.)
(5) Remove the 4 installation screws (M5×28). (See Photo
10.)
(6) Release the 2 temporary hanging hooks to remove the
grille. (See Photo 11.)
OCH640C
Photo 9
Lead cover
Nut washer
Clamp
(2 points)
Figure 4
Corner panel
Corner panel
Photo 10
Photo 11
40
PHOTOS/FIGURES
Nuts and washers
Rubber mounts
Lead cover
Coil plate
Screw
Close-up
①
Grille
①
Temporary hanging hook
Fan motor
Installation
screw