Datamax IClass Installation And Operating Instructions Manual page 21

Diagnostics
The following features have been added on the operator's front panel menu under "DIAGNOSTICS" →
"OPTIONS TESTING" → "TEST RFID" → "TEST HF" OR "TEST UHF".
Upon selection the display will show "NOT INSTALLED" if the device is not equipped or not
communicating and then proceed to the Mode selection.
•
"TAG DATA" – This acts as an RFID reader and will read and display data from block zero
through ten for HF or the entire tag for UHF. If the tag cannot be found after 10 tries a message
"Cannot Read RFID Tag" will be displayed.
•
"DEVICE VERSION" – This queries and displays the serial number of the RFID programming
device and the firmware version. This is useful for verifying the device is communicating
properly.
"TAG ID" – (HF only) This queries and displays the unique serial number for the tag.
•