Datamax IClass Installation And Operating Instructions Manual page 14

STX KtU Read Unique Serial Number from RFID Tag
This command instructs the RFID device to read the unique serial number data from the tag and put it in a
replaceable field. It is expected that the tag transponder is within read/write distance of the RFID
programming device otherwise a "Void" will print in the text or barcode label fields.
Syntax:
Where:
Note: This is a sixteen character alphanumeric value so the replaceable field should be adequate in
length.
STX KtA Write Application Family Identifier (AFI) to Tag
This commands writes the AFI data to the tag.
Syntax:
Where:
Sample:
This example writes 0xC3 AFI byte, locking value, retrying 9 times if necessary.
STX KtD Write Data Storage Format Identifier (DSFID) to Tag
This commands writes the DSFID data to the tag.
Syntax:
Where:
Sample:
This example writes 0xC3 DSFID byte, locking value, retrying 9 times if necessary.
<STX>KtUabcc
a - Number of retry attempts, 0-9
b - Reserved. Should be 0.
cc - Field name where to place data. Must be 01, 02, 03, etc...
matching the order of label formatting command U.
Note: a 00 value will send read data to host with no printing.
<STX>KtAabcc
a - Number of retry attempts, 0-9
Lock AFI after writing
b - 0 - No Protection
1 – Write Protect
cc - Two character AFI value representing one byte.
<STX>KtA91C3[CR]
<STX>KtDabcc
a - Number of retry attempts, 0-9
Lock DSFID after writing
b - 0 - No Protection
1 – Write Protect
cc - Two character DFSID value representing one byte.
<STX>KtD91C3[CR]