Front Panel Controls And Indicators - Bryston SP 1 Series Instructions Manual

CONTROLS AND CONNECTIONS - OVERVIEW

Front Panel Controls and Indicators

Figure 3: Front Panel
When looking at the front panel of the SP1 you will see the
following controls and displays from left to right:
1. Power [Momentary Switch]
Toggling this switch up or down takes the unit in and out of
its' Standby power mode (see above)
2. Standby and (IR) Infrared Activity Indicator
If this LED is continuously bright, it is an indication that the
SP1 is in Standby mode. When the SP1 is powered up, the
LED is OFF, and flashes when a valid IR code is detected.
3. (IR) Infrared Receiver/Sensor for remote control
4. Dynamic Range Control
This three position switch, which will operate only when the
SP1 is in a Dolby Digital mode, permits the adjustment of the
dynamic range (softest sound to loudest sound) of signal
sources producing a Dolby Digital bitstream.
4