Bryston SP 1 Series Instructions Manual page 16

14
The SP1 Remote Control
Operating the SP1 from the Remote Control is similar to the
front panel operation, with a few additions and omissions.
1. Source Select Buttons
These buttons are used to select the desired source, and
function exactly like their equivalent buttons on the front
panel.
2. Mode Select Buttons
These buttons are used to change the SP1 decoding mode, and
function exactly like their equivalent buttons on the front
panel.
3. Mute Button
Pressing this button will fully mute the output of the SP1.
4. Volume/Trim Buttons
These buttons increase and decrease the
master volume. When the SP1 is in its
Test/Noise mode, these buttons are used to
adjust the level trim for each individual
speaker.
5. Light/Test Button
When pressed momentarily, this button will illuminate the
backlight on the Remote Control. If pressed for more than 3
seconds, the SP1 will enter the Test/Noise mode. Please see
Page 18 for more details on this mode.
6. Power Button
Pressing this button will toggle the SP1 in and out of the
Standby power mode.
{Installers: please contact Bryston technical support for information about
Discrete On/Off control}