Lcd Display Window - Bryston SP 1 Series Instructions Manual

Figure 4: Status display showing Dolby
Digital 5.1 channel signal at input
Figure 5: Status display showing analog
input signal and Pro Logic decoding
6
USING THE DYNAMIC RANGE CONTROL
For the majority of applications this switch should be placed
and remain in the middle or NORM position.
For late night viewing or at any time you wish to reduce the
overall dynamic range of a program the switch may be set to
the "LATE" (down) position.
If you wish to turn off all of the software's built-in dynamic
range management functions the switch can be set to the
"MAX" (up) position.
NOTE: Caution should be exercised when choosing this option. Many
smaller loudspeaker systems cannot handle the extremely wide range
signals produced in this mode. Overall system volume should be initially
set quite low until you or your dealer are able to determine the maximum
safe setting to avoid damage to your loudspeaker systems or power
amplifiers.

5. LCD Display window -

green 16 character per line alphanumeric display which
indicates the status and functional mode of the SP1.This
screen is also used during the menu-setup function for
calibration of the SP1 to your system.
On the first line, the decoding type [Dolby Digital, DTS, Pro-
Logic, Music, etc.] is displayed.A sample screen is shown
below: (FIG 4)
On the second line, the type of signal being detected from the
currently selected input is displayed.A sample screen is
shown below: (Fig 5)
contains the two line, black on