Canon Puncher Unit-L1 Installation Procedure page 19

[3]
F-1-16
<Finisher-R1/Saddle
Saddle Finisher-T2>
(The figure shows the Finisher-R1.)
[3]
F-1-17
7) In the case of the Saddle Finisher-Q2/Saddle
Finisher-Q4/Saddle
Saddle Finisher-T2, close the front cover. In the
case of the Finisher-Q1/Finisher-Q3/Finisher-R1,
mount the front cover using 3 screws.
8) In the case of the Saddle Finisher-Q2/Saddle
Finisher-Q4/Saddle Finisher-R2, remove the foot
cover and the extension cover (if Saddle Finisher-
Q2/Saddle Finisher-Q4).(For the Finisher-T1, it is
not necessary to remove them.)
<Saddle Finisher-Q2/Saddle Finisher-Q4>
Remove the 2 screws [1] and [2], and detach the lower
front extension cover [3]. Remove the screw [1], and
detach the front foot cover [4]. Remove the screw [1],
and detach the rear foot cover [5].
[2]
[1]
Finisher-R2/Finisher-T1/
[2]
[1]
Finisher-R2/Finisher-T1/
[1]
[5]
[3]
[1]
[4]
F-1-18
<Saddle Finisher-R2>
Remove the screw [1], and detach the front foot cover
[2].Remove the screw [1], and detach the rear foot
cover [3].
[1]
[2]
F-1-19
9) In the case of the Finisher-Q1/Finisher-Q3, remove
the 2 screws [1], and detach the inlet guide [2];
then, remove the 4 screws [3], and detach the right
cover [4].
F-1-20
If the finisher is a Finisher-Q1/Finisher-Q3/Saddle
Finisher-Q2/Saddle Finisher-Q4 and, moreover, a
rubber sheet that comes with the buffer pass unit is
attached to the pickup surface of the finisher, leave the
Chapter 1
[2]
[3]
[1]
[4]
[3]
[2]
[3]
[1]
11