Canon Puncher Unit-L1 Installation Procedure page 14

Chapter 1
[1]
[5]
[2]
[3]
[6]
[4]
F-1-5
* 3. Some models come with the 3 Way Unit-A1 as standard.
Be sure to go through the following steps on the host machine before starting the work
1. Hold down the control panel power switch for 3 sec or more.
2. Go through the shutdown sequence as instructed on the screen so that you may turn off the main power switch.
3. Turn off the main power switch.
4. Disconnect the power cable (from the wall outlet).
＜ When installing the Finisher-T1 or the Saddle finisher-T2 to the iR 6570/5570 series ＞
1. Side paper deck (Refer to "Installation Manual for Side paper deck".)
2. Finisher [1], [2] (Refer to the part from the beginning to the "Preparation of the Finisher for installing" in this
manual.)
3. Puncher unit [3] (Refer to "Installation Manual for Puncher unit".)
4. Connecting to the host machine. (Refer to this manual or the part of "Connecting to the host machine" and the
rest in the "Installation Manual for Puncher unit".)
6