Canon iR1018 Series Installation Procedure page 14

Chapter 1
MEMO:
The removed screw will be used later.
2) Remove the screw [1] securing the ground cable,
and then separate the card reader [3] from the card
reader mount [2].
[1]
[2]
When removing the harness [1] through the opening
in the card reader mount, take care not to cut or dam-
age it.
MEMO:
The removed card reader mount is no longer neces-
sary.
6
[3]
F-1-8
[1]
F-1-9
3) Insert the card reader [2] harness and ground cable
into the hole in the supplied card reader mount [1].
Using the screw [3] removed in step 1) of "2. Instal-
lation of the card reader", secure the card reader to
the card reader mount.
When inserting the card reader [2] harness and ground
cable into the hole in the supplied card reader mount
[1], take care not to cut or damage them.
[3]
[2]
F-1-10
4) Using the supplied binding screw (M4x6) [1], con-
nect the ground cable [2] to the reader mount. At-
tach the supplied edge saddle [3] to the card reader
mount.
[2]
F-1-11
5) Attach the supplied cord retainer [1] at the position
about 4 cm (A) away from the connector (with a
protective cover) of the supplied repeating harness
A. Cut out the excessive portion of the band.
[1]
[3]
[1]