How To Program - Danfoss VLT 2000 Series Manual

How to program

The Quick Setup shown is based on the assumption
that you want your VLT to operate with the following
setup:
1. External start/stop
2. Potentiometer connected for external speed control
3. Option to change rotation direction
4. Option to select a fixed speed (Jog)
Standard motor with constant torque load without brake module on the frequency converter
Step Parameter Designation
1 000 Language
2 103 Motor power
3 104 Motor voltage
4 105 Motor frequency
5 201 Min. frequency
6 202 Max. frequency
7 215 Ramp up 1
8 216 Ramp down 1
9 Start
the frequency
converter
If a brake module is mounted, make the following settings
Step Parameter Designation
1 300 Brake function
2 Start
the frequency
converter
If you want local operation and start, make the following settings
Step Parameter Designation
1 003 Operation site
2 004 Local reference
MG.20.B6.02 – VLT is a registered Danfoss trademark
VLT ® 2000 Series
If you use a brake module, you must program
one parameter more, and two more if you
want local operation via the display keys.
This will appear from the two tables at the bottom.
To store the data press the "menu" key!
When you have connected your VLT, as described on
the previous page, you must program a few parame-
eters.
Perform steps 1-9 for Quick Setup.
Settings
Choose English
Read motor plate
Read motor plate
Read motor plate
Set wanted frequency
Set wanted frequency
Set wanted ramping time
Set wanted ramping time
This is done by supplying terminals 18 and 27
with 24 V DC from the frequency converter's terminal 12
or by using an external 24 V DC voltage
Settings
If a brake module is used, choose Applied
This is done by supplying terminals 18 and 27
with 24 V DC from the frequency converter's terminal 12,
or by using an external 24 V DC voltage
Settings
Choose Local
Record wanted output frequency by means
of the "+" and "−" keys
Display indication
ENGLISH
Display indication
APPLIED
Display indication
LOCAL
15