Important Notes - Rehau RAUTOOL A-LIGHT2 Operating Instructions / Technical Information

RAUTOOL A-LIGHT2

ImpORTAnT nOTes

failure to observe these instructions may result in material damage and/or personal injury .
Attention:
Do not touch moving parts (risk of
trapping fingers)!
When using an expander bit, check
to make sure that the seating (fully
inside the jaws) and clamping action
of the bit in the jaws are correct (to
avoid falling out).
12.05.2010
failure to observe these instructions may result in material damage .
Attention:
Do not expand the pipe under
bending stress!
Expanding tool and pipe axis must
be identical in the expansion area
(approx. three compression sleeve
lengths):
if necessary, readjust the pipe by
bending.
Never work with a damaged
expander head as this will damage
the pipe! Replacements are available
from your dealer or from the REHAU
sales office.
RAUTOOL A3 Strichzeichnungen, MAM-Bezeichnungen Korrekturexemplar 2 vom 20.05.2010
ZGT_07723
ZGT_07724
ZGT_07707 - muss im Layoutprogramm durchgestrichen werden!
1
Always apply clamping jaws or
jointing technique at right angles,
making sure they completely contact
the entire surface.
Make sure the fitting is correctly
seated in the tool. Applying the tool
to the wrong fitting collar will over-
compress the joint!
As a matter of principle, always
insert the expanding tool into the
pipe up to the stop.
Do not tilt the expanding tool!
Regularly grease the expander taper
(tube of lubricant included). To avoid
excess grease entering the pipe, do
not grease the taper too much.
Attention:
Do not grease the expander seg-
ments that are in contact with the
pipe!
Your tool is equipped with the REHAU
RO expander system. In order to
avoid damage to the pipe, do not
use REHAU RE expander system
parts (until 1996) with RO expander
system components!
en
29