Advertisement
RAUTOOL G 125/160
IMPORTANT INFORMATION
Always fi t clamping jaws or jointing systems so that they lie fl at and at
a right angle!
Caution!
Do not touch moving parts (risk of trapping fi ngers)
- After use, clean and oil the tool.
- Then store the tool in a dry place.
12
Always insert the expander into the pipe up to the stop and do not tilt
it.
Tips and tricks
- Using a rubber mallet, the compression sleeve can be tapped out a
little before pressing, so that it may be possible to use the second
pin hole immediately
=> No need to change the position of the pin
- For the size 125, the stroke can be increased by rotating the
eccentric reducer.
=> No need to change the position of the pin
- To remove the air, raise the pump motor and lower the clamping
tool. Actuate the tool several times without running at maximum
pressures.
Advertisement
