Installation - Electrolux EN3850DOX User Manual

Problem
The lamp does not
work.
"dEMo" appears on
the display.
The buzzer sounds.
The Display is red..
Upper or lower
square is shown in
the temperature dis-
play.
As much as the advice does not lead to result, call the nearest brand-mark service.
8.1 Closing the door
1. Clean the door gaskets.
2.
If necessary, adjust the door. Refer to

"Installation".

9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
9.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Possible cause
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The appliance is in dem-
onstration mode.
The door is not closed
correctly.
An error has occurred in
measuring the tempera-
ture.
3.
Cli-
mate
class
SN
N
ST
T
9.2 Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
Solution
Connect a different electri-
cal appliance to the mains
socket. Contact a qualified
electrician.
Close and open the door.
Keep pressed approxi-
mately 10 sec the OK but-
ton since a long sound of
buzzer is heard and the dis-
play shut off for a short
while: appliance start works
regularly.
Refer to "Door open
alarm".
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
If necessary, replace the defective
door gaskets. Contact the Service
Center.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
ENGLISH 21