Table of Contents
Advertisement
The remote control allows you to operate the function keys on the projector and to emulate mouse function when the
projector is connected to a computer.
Main Unit
Standby/On
Freeze
Magnify
Disk Pad
Menu
Blank
Source
Return
Volume
Laser
Mouse Left-Click
Mouse Right-Click
Exit
i-key
Inserting Batteries in the Remote Control
Be sure to follow instructions in placing batteries into the remote control units.
Push and slide the lid in the direction of the arrow.
Install two 'AAA' batteries as indicated inside the battery compartment.
Replace the lid and snap into place.
Caution
Avoid excessive heat and humidity.
Do not mix new and old or different types of batteries.
Figure 15. Battery replacement process
10
English
To turn the projection lamp on and off.
Pressing this button displays a still (frozen) picture.
Pressing this button partially magnifies a displayed picture.
(Move the picture with the Disk Pad after pressing the Magnify button.)
When the OSD menu is active, Disk Pad acts as
on-screen menus are not active, it works as mouse pad. When the magnify function is
active, use disk pad to move through the picture.
Call the OSD Menu.
The blank screen is displayed by pressing Blank. And the blank screen will be revealed
partially from top to bottom by pressing Blank again.
Selects the input source.
Image ration backs to 1:1.
Adjusts volume. The sound gets louder or quieter by pressing the "+" or "-" button.
Laser pointer on button. Use as a stick (for indication).
When operating in mouse emulation mode, it registers a left mouse click.
When operating in mouse emulation mode, it registers a right mouse click.
To leave current OSD Pages.
To adjust position, phase automatically.
Function
selecting device. When the
Advertisement
Table of Contents
