Playback - Rebis Audio RA226 User Manual

Playback:

There are four different playback modes which can be used in either
direction and are defined by the state of the Loop and Latch switches in
combination as follows:
1. Loop and Latch off.
The sample plays once only in the selected direction while the play
button is held down. Pushing either play button at any time always
starts the playback from the selected end.
2. Latch on.
The play buttons only have to be touched to start playback in the se-
lected direction once only. Touching the opposite play button before the
end of playback reverses playback from the point reached.
3. Loop on.
The sample is played for as long as the play buttons are held down in
a continuous cyclic loop in the selected direction. The sample is played
each time from the point last reached.
4. Latch and Loop on.
The play buttons only have to be touched to start continuous cyclic
playback in the selected direction. Touching the same play button again
stops the playback, touching it again restarts playback from the end se-
lected. Touching the opposite play button whilst in playback reverses
the playback from the point reached.
A few minutes experience with the RA226 audibly demonstrates that
these play modes simply provide a vast range of sample effects.
the same as the maximum sample time and is dependant on the number
of expansion boards installed.
Once the Delay button has been pushed and the Delay LED is on
then the End control sets the actual delay time obtained as a percentage
of whichever maximum time has been selected.
When the maximum delay time is 1.3 seconds the delay mode uses
the last 1.3 seconds of memory only, any samples stored in memory up
to this point will not be affected by using the Delay mode. However
when the full delay time is selected all of memory is used and any sam-
ples will be lost.