Editing; Multiple Samples; Drop-Ins - Rebis Audio RA226 User Manual

Editing

The START and END controls define which part of the recorded sam-
ple will be played.
1.Turn the START control CW to edit from the front of the sample.
2.Turn the END control ACW to edit from the end of the sample.
Swap the positions of these two controls to remove a "window" from
the sample.
Note: START/END settings are scanned at the moment the sample
starts to play therefore adjusting the END control while sample is play-
ing will have no effect until next play.
To save time when editing long samples it is advisable to adjust the
end point first. i.e.Set the START control a little before the required end
point to save playing the whole sample.
It is also worth considering use of the REVerse and PITCH controls to
assist precise editing.

Multiple Samples

The START and END controls can be adjusted prior to recording a
sample to define the memory zone which it will occupy.
This facility can be used to reduce the time taken to record short sam-
ples. It also allows several samples to be stored in memory simultane-
ously and short samples to be inserted in longer ones.
Drop Ins
The RA226 can be switched in and out of record to perform orthodox
drop ins.
1.Set mode, LATCH on, LOOP off.
2.Play sample with FWD button held down.
3.Press REC button and RA226 will start recording. (Both buttons can
now be released).
4.Press REC button to drop out of record.