Multiple Samples; Editing - Rebis Audio RA226 User Manual

of this manual. In addition you can try varying the pitch of the sample
whilst in playback with the Pitch control.
Sampling: (cont)
Samples can be recorded into any part of memory by setting the Start
and End controls to define the section before pushing the Record but-
ton, but make sure that the End control is set more clockwise than the
Start control.

Multiple Samples:

Multiple samples can be recorded into memory by adjusting the Start
and End controls before recording each sample. These samples can then
be played back independently by resetting the Start and End controls to
the original settings before pushing the FWD button.
Samples can be 'dropped into' any section of an existing recording by
defining the section beforehand with the Start and End controls.
A special remote control unit will soon be available which will allow
up to eight user defined sections of memory to be played back instantly
in either direction.

Editing:

All of the recorded material can be heard by setting the Start control
fully anticlockwise, the End control fully clockwise and pushing the
FWD button. Any recorded sample can be edited down to individual
notes by the use of these same controls.
If the Start control is set later in memory than the End control when
the sample is played then the whole of memory is played except the
section between the controls. This is useful in editing out part of a sam-
ple which is not required.
Setting any controls or operating any buttons except Delay and
Record will not permanently alter any sample in memory but merely
select a different section to be played back. Feel free to experiment with
the edit controls and playback modes described later, you cannot dam-
age your sample, it will all still be in memory if you require it.