Delay/Echo; Phasing; Keyboard Control - Rebis Audio RA226 User Manual

Delay/Echo

To enter delay mode set START control to 0%, MIX control to IP, and
press DELAY. With the PITCH control set to +1 the RA226 will now
provide up to 1.4 seconds delay at 16kHz bandwidth. The END control
adjusts delay length and repeat echo can be introduced with the FEED-
BACK control.
The dry signal can be removed by turning the MIX control to OP.
In this mode only the last 1.4 seconds of memory is used, so samples
stored in the rest of memory will not be erased.
If you wish to use the entire memory, set the START control to 100%
before selecting DELAY.
Phasing/Tube effects
Set MIX control midway
Adjust INPUT control
Set START control to 0%
Set END control to 0%
Press DELAY
Manual phasing can now be created with the PITCH control.
Turn MIX control to IP
Add FEEDBACK
PITCH control now gives resonant tube effect.
Both these effects can be controlled musically by using a CV keyboard
instead of the PITCH control.

Keyboard Control

Any keyboard or sequencer equipped with a 1 volt per octave CV and
gate outputs can be used for musical control of samples.
When the keyboard is connected it takes over the role of the PITCH
control during recording as well as playback.
The last key pressed before recording will define the PITCH setting.
This key will be the reference point for play back of the sample from
the keyboard. (Refer to Pitch Shift section). The PITCH control itself
now acts as a fine tune control.